![]() If everything looks good, tighten the screws. ![]() You should have almost a 90 degree angle on the bigsby from the top to the tailpiece. Keep everything loose for now, don't tighten it up just yet.Ĭheck to see how the bigsby lays on the guitar. If everything is lined up, drill the 4 holes for the tail piece and screw in the 4 screws and the strap lock. Make sure everything lines up before you mark these holes because now you get to drill the first holes. ![]() When this alignment is done, mark the 4 holes on the tailpiece. Make sure that both strings are perfectly square down the fretboard. Run it back down the fretboard, throught the high e nut groove to the high e anchor. Low e anchor, up the fret board, through the nut and over th the high e string. Use the string that comes supplied with the bigsby. then put the bigsby on and replace the strap pin loosely. First, remove the strap pin from the back of the guitar.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |